www.AlnoHardware.net – Alno Hardware, Alno Accessories and More
Cabinet Back Plates Questions
A question for innovators?
I have 2 cabinet door panels, that are a hair to big for the door opening. I have already done some hinge adjustments but still to tight. I only need to take off about a 32nd. to a 16th. for a nice fit. I would rather sand that smidge off , but I want it even. Has anyone ever tried to make a backing pad for sanding that will fit on a table saw? If so what kind of material did you use. I was wondering about a 1/4 ” x 8″ plate made out of that real hard pressboard. Cutting , centering and truing the plate is no problem, but will it take the motor rpm? Need an answer fairly quick, would like to finish this project by next Friday 11-10-06. Thanks.
that’s way to complicated you just need a 2×4 longer then the piece your sanding cover it in sand paper as long as its already even you’ll have no problems.
